Changing a flat (Flo 30's)

FLO Product Support, FAQ, Cycling, Triathlon, Etc.

Re: Changing a flat (Flo 30's)

Postby gatorsportsnut » October 15th, 2014, 6:05 am

A trick that I learned from one of the mechanics at the LBS I work at part time with installing the GP 4000's or any foldable tire, is to work the tire on until it gets to the point where it seems like it won't go any further, place the tire on the ground with the seated part up top, and work the slack towards the remaining section by physically pushing it towards the bottom part that isn't yet seated. You'd be surprised how much slack is actually in the tire. Once this is done, it will typically slide right on without the use of a tire lever.
gatorsportsnut
 
Posts: 2
Joined: February 19th, 2014, 6:08 am

Re: Changing a flat (Flo 30's)

Postby PaulM » November 15th, 2014, 10:48 am

Mt GP4000s FLO30 experience was the worst I've had too (no problems with the 60).
At the moment I'm carrying a tire bead jack. I'll try removal over winter & see if the conti has stretched.
PaulM
 
Posts: 3
Joined: October 16th, 2013, 2:11 pm

Re: Changing a flat (Flo 30's)

Postby Chris Thornham » November 15th, 2014, 10:31 pm

Chris Thornham
FLO Cycling:
FLO Blog: | Twitter: | Facebook:
Chris Thornham
Site Admin
 
Posts: 588
Joined: March 2nd, 2012, 3:35 pm
Location: Las Vegas, Nevada

Previous

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest