Stickers

FLO Product Support, FAQ, Cycling, Triathlon, Etc.

Stickers

Postby Sobyschwartz » August 3rd, 2016, 1:45 am

My beloved Flo60/90 wheelset from presale#2 are still running strong but the colors of the stickers do not match my new frame. So, old stickers have been removed, new one ordered and I have received a shipping mail from you.
Can you give me some hints on how to put the stickers on the easiest way to avoid air bubbles and other problems? Any video perhaps?
Sobyschwartz
 
Posts: 1
Joined: August 2nd, 2016, 11:45 am

Re: Stickers

Postby Chris Thornham » August 5th, 2016, 11:39 am

Sobyschwartz wrote:My beloved Flo60/90 wheelset from presale#2 are still running strong but the colors of the stickers do not match my new frame. So, old stickers have been removed, new one ordered and I have received a shipping mail from you.
Can you give me some hints on how to put the stickers on the easiest way to avoid air bubbles and other problems? Any video perhaps?


Thanks for writing. I'd make sure you clean the surface well before applying the sticker. That will prevent any debris from getting under the sticker. After that, start applying the sticker from the center and slowly lay the sticker down until you get to the edges. If you get any air bubbles you can take a fine pin and poke the center of the bubble. That will remove the bubble and allow the sticker to lay flat.

I hope that helps,
Chris Thornham
FLO Cycling: http://www.flocycling.com
FLO Blog: http://bit.ly/b3Zlpq | Twitter: http://bit.ly/bOQ08x | Facebook: http://bit.ly/d8KDhI
Chris Thornham
Site Admin
 
Posts: 576
Joined: March 2nd, 2012, 3:35 pm
Location: Las Vegas, Nevada


Return to General Discussion

Who is online

Users browsing this forum: No registered users and 1 guest